Solar Panel Mount Standing Seam Roof Hook
1.Technical Parameter ---Solar Panel Mount Standing Seam Roof Hook
Installation Site: | Standing Seam Roof Hook |
Applicable Roof Cladding: | Suitable for most types of cladding |
Roof Slop: | Up to 60 degree |
Max. Building Height: | Up to 65ft(20m) |
Wind Load: | 130mph(60m/s) |
Snow Load: | 30psf(1.4kN/m2) |
Applicable Module: | Framed |
Module Orientation: | Landscape or portrait |
Standard: | AS/NZS 1170; |
Material | Aluminum, stainless steel |
Warranty: | 10 years on material |
2.Details of Solar Panel Mount Standing Seam Roof Hook
How to Install Distributed Flat Roof Photovoltaic Support |
(1) The bracket is mounted in the bracket installation mode. The battery assembly is supported by a metal frame and presents a preset inclination angle. A square array mounted with a bracket is fixed to the roof by screw. This installation method will bring about problems such as increasing roof load and wind stress. However, because the airflow path completely surrounds the battery module, the module can maintain a relatively low operating temperature, thus improving efficiency. Some mounting methods can adjust the inclination angle according to the season to improve the efficiency of photovoltaic system. (2) Battery assemblies are mounted on the roof frame, which is parallel to the inclination angle of the roof and is lO~20cm high from the roof. The supporting crossbars are fixed on the frame, and the components are fixed on these crossbars. Installation provides a free air flow path for the square array. The disadvantage of the installation method is that it is difficult to maintain the square array and replace the roof material. (3) Direct installation installs the battery assembly directly on the cover of the common roof, so there is no need to support the frame and the crossbar. Components must maintain the integrity of roof coverings, so often
4. ISO Certificate for Solar Panel Mount Standing Seam Roof Hook
Please feel free to contact me if you have any demand.